
netRAPID 90
- 一個硬體支持所有工業乙太網和現場總線協議
- 通過SPI進行與主機連接
- 提供高效通信的編程平台
- 適用於寬溫範圍的節能高效設計
- 內建加密核心,確保設計安全
NRP H90-RE | Parameter | Value |
Communication controller | Type | netX 90 |
SDRAM | Internal (COM CPU) | 576 kB |
Internal (APP CPU) | 64 kB | |
FLASH | Internal (COM CPU) | 1024 kB |
Internal (APP CPU) | 512 kB | |
Ethernet interface | Transmission rate | 100 MBit/s 10 MBit/s (depending on loaded firmware) |
Half duplex/Full duplex | supported (at 100 MBit/s) | |
Auto-Negotiation | depending on loaded firmware | |
Auto-Crossover | depending on loaded firmware | |
Galvanic Isolation | Isolated | |
Host interface | Type | |
Serial dual-port memory interface | SPI Slave, mode 3 (CPOL = 1, CPHA = 1) | |
Serial transmission rate | Max. 50 MHz | |
Connector Type | 54-pin solder contacts 1 mm with 0.8 mm grid | |
Diagnostic Interface | UART | RXD, TXD (depending on loaded firmware) |
Ethernet | ||
Security functions | Security module | Crypto core within netX 90 |
Power supply | Voltage | +3.3 V ± 5 % DC |
Power Consumption (typ.) | approx. 1 W (stand-alone use) approx. 0.8 W (use as companion chip) |